FINAL CLEARANCE FOR THESE LISTED PARTS
Please contact John Beaudoin at john_beaudoin@shaw.ca or 778 822 7755
Located in North Vancouver.
Nothing listed is new, but many of the parts are in very good condition or hard to find. You must pick them all up all or pay shipping for the lot . No individual parts.
100
Set of shut face finishers
(2) Boot hinges
Boot lid striker
(2) Tonneau cover retainer
(2) Windscreen feet
Rear view mirror post
(2) Door check straps
(2) Door strike assemblies (with shims)
Grille surround (needs some straightening)
(2) Fender flashes (one has two broken studs)
Clutch linkage
(2) Kingpins (serviceable)
(2) 12 threads per inch knockoffs
Choke cable bracket (between the carbs)
Generator fan
(1) Front radiator brace
Oil pump feed pipe
Steering idler
Engine vent pipe
Water pump pulley
Timing chain cover
Purolator oil filter housing and head
Timing gear and oil slinger
Voltage regulator (screw terminals)
Choke cable (31” long)
Complete windscreen frame
BN4 to BT7
Set of side curtain frames (need new windows and seals)
Set of shut face finishers
Coil mounting bracket
Smiths heater blower with metal housing
Six-cylinder hood latch assembly
Solenoid bracket cover (BN7 to BJ8)
Fuel filler cap and connector pipe (BN4 to BJ8)
Water pump (rebuildable)
Pedal box, brake and clutch arms and pedals (BN4 to BJ8)
Overdrive solenoid bracket
Door check strap assembly
Engine tie rod (BN4 to BJ8)
Heater hose and elbow
Shift lever, lever seat and cover
Windscreen washer bottle and mounting bracket (rusty)
Lucas starter solenoid
(2) Voltage regulators (blade terminals)
BJ8
Water pump (rebuildable)
Original 12-volt battery fixing bar and rods (rusty)
(2) 8 threads per inch knockoffs
Sprite
Set of side curtains for Sprite (need new rubber seals)
Seat covers (both sides) black with black piping
All Model Applicable
(3) Bullet mirrors
One Lucas 6” driving /fog light rim
(2) Lucas 6” driving/fog light shells
Package of various Healey brackets (unidentified)
SU fuel pump fitting
Other models/generic
Generator mounting bracket (cast aluminum, vehicle unknown)
(4) Strips of fender beading (each 49 1/2” long)
Generic master switch
PCV valve (MGB, triumph 2,3,4, Spitfire and AH Spite/MG Midget)
Various gauges (Jaeger oil/water combo gauge with red tip needles (needs repair), Smiths electric water temperature gauge, Smiths Ammeter, generic water temperature gauge in Fahrenheit, generic ammeter, Smiths gauge mounting brackets, 2 lengths of oil pressure gauge copper line with fittings)